frps 完整配置文件

网络技术4年前 (2020)发布 fdadmin
5,430 0 0
# [common] is integral section
# A literal address or host name for IPv6 must be enclosed
# in square brackets, as in "[::1]:80", "[ipv6-host]:http" or "[ipv6-host%zone]:80"
bind_addr =
bind_port = 7000

# udp port to help make udp hole to penetrate nat
bind_udp_port = 7001

# udp port used for kcp protocol, it can be same with 'bind_port'
# if not set, kcp is disabled in frps
kcp_bind_port = 7000

# specify which address proxy will listen for, default value is same with bind_addr
# proxy_bind_addr =

# if you want to support virtual host, you must set the http port for listening (optional)
vhost_http_port = 80
vhost_https_port = 443

# set dashboard_addr and dashboard_port to view dashboard of frps
# dashboard_addr's default value is same with bind_addr
# dashboard is available only if dashboard_port is set
dashboard_addr =
dashboard_port = 7500

# dashboard user and pwd for basic auth protect, if not set, both default value is admin
dashboard_user = admin
dashboard_pwd = admin

# dashboard assets directory(only for debug mode)
# assets_dir = ./static
# console or real logFile path like ./frps.log
log_file = ./frps.log

# trace, debug, info, warn, error
log_level = info

log_max_days = 3

# privilege mode is the only supported mode since v0.10.0
privilege_token = 12345678

# heartbeat configure, it's not recommended to modify the default value
# the default value of heartbeat_timeout is 90
# heartbeat_timeout = 90

# only allow frpc to bind ports you list, if you set nothing, there won't be any limit
privilege_allow_ports = 2000-3000,3001,3003,4000-50000

# pool_count in each proxy will change to max_pool_count if they exceed the maximum value
max_pool_count = 5

# max ports can be used for each client, default value is 0 means no limit
max_ports_per_client = 0

# authentication_timeout means the timeout interval (seconds) when the frpc connects frps
# if authentication_timeout is zero, the time is not verified, default is 900s
authentication_timeout = 900

# if subdomain_host is not empty, you can set subdomain when type is http or https in frpc's configure file
# when subdomain is test, the host used by routing is
subdomain_host =

# if tcp stream multiplexing is used, default is true
tcp_mux = true
© 版权声明